Flexoid Gasket Material - Any Thickness - 1000 mm x 500 mm
As low as
£2.89
Regular Price
£3.04
In stock
In stock
SKU
Flexoid
FLEXOID is a plasticised gelatine impregnated material, cellulose based gasket material. The prime market for this material is the automotive sector, but it is also extensively used in other industries i.e. water jet cutting etc.
It is a very economical material, especially where price is a factor when dealing with original equipment and replacement markets.
Characteristics
Advantages
- Excellent oil and fuel resistance
- Seals better at lower cost
- Available in roll or sheet form over a wide range of thicknesses
Limitations
- Stored gaskets must be protected from wide changes of humidity and temperature to prevent dimensional change
- Not suitable for alkalis, acids and steam
- Maximum recommended service temperature: 120°C
Uses
- Prime market: automotive
- Limited uses in industrial markets because of relatively low heat and chemical resistance compared with other non-asbestos materials.
- Because of its ability to seal against petrol, oil and water at low cost, Flexoid is used extensively by leading British, European and US automotive manufacturers
- Flexoid has a major market share in the big four of the European Economic Community, i.e. U.K., Germany, France and Italy
Basic Engine
- Carburettor; Fuel Pump; Front Plate; Oil Pump; Oil Filter; Side Cover; Timing Cover; Thermostat; Water Pump
Gearbox
- Input Shaft; Exit Housing; Top Cover; Gearbox to Clutch.
Rear Axle
- Axle Cover; Axle Shaft.
Roll Description
- Material is supplied in rolls 1 metre wide on 70mm I.D. cores
- Width Tolerance:
- For 0.15 mm – 0.80 mm Thickness: 1000 – 1050 mm tolerance
- For 1.00 mm – 6.40 mm Thickness: 1000 ± 5 mm tolerance
- Thickness Tolerance:
- ± 10% on nominal
Manufacturer | Jointine |
---|
Write Your Own Review